Manual |link|: Zm7205a

: Must be set to "ON" for motors using Hall sensors to avoid "Error 01".

The ZM-7205A often requires the for configuration. The driver has 8 main parameters that can be adjusted to match your specific motor: Description P Set based on motor pole pairs. S Speed / RPM Set maximum motor speed (250-3000 RPM). C Current / Amp Limit motor current (supports up to 5A). F Accel Time Define the start acceleration time. H Hall Enable Turn Hall sensor feedback ON or OFF. L Set to ON for closed-loop (precision), OFF for open-loop. Setting Up a New Motor Connect the BL01 programmer to the driver. Navigate the menus using the keys to select parameters. zm7205a manual

Set the pole number ( P ) by dividing the number of permanent magnets in your motor by two. : Must be set to "ON" for motors

: Reversing the power supply will burn the drive immediately . Additionally, the speed control signal must not exceed 5V , or the unit will fail. S Speed / RPM Set maximum motor speed (250-3000 RPM)