Sunlu T3 Firmware

Allows you to adjust the Z-offset in real-time during the first layer of a print.

Adjusts acceleration and jerk settings to actually achieve the advertised 250mm/s limits safely. Option 1: Official Sunlu T3 Factory Firmware sunlu t3 firmware

Thanks for any pointers!

The stock touchscreen uses protocol. In _Statusscreen.h , disable legacy LCD and enable: Allows you to adjust the Z-offset in real-time

You must compile Klipper firmware for your specific T3 MCU (usually STM32F103 ). You will permanently lose the stock LCD screen UI unless you install KlipperScreen on a touch display. This is for tinkerers only. sunlu t3 firmware