Once the component is placed in your schematic workspace, wire the simulation circuit using the following configuration:
Proteus Design Suite is a powerful software for simulating electronic circuits, but it does not come with all sensor models pre-installed. To simulate the ZMPT101B, you need a custom library file (usually .idx and .lib or a .pdsym file) that defines the component's schematic symbol and electrical behavior. zmpt101b proteus library
Which (e.g., 8.13, 8.16) are you currently using? Once the component is placed in your schematic
+--------------------------------------------+ | ZMPT101B Module | | | | [ AC IN ] ----> [ Isolation Trans. ] | | | | | v | | [ Op-Amp Buffer ] | | (2.5V DC Offset) | | | | +---------------------------|----------------+ | v Analog Signal (0-5V Sine Wave) +----------------------+ | Arduino Uno (A0) | +----------------------+ Microcontroller Connection 8.16) are you currently using?